beautypg.com

Cleaning the oven door, Replacing the light bulb, Automatic cleaning mode – Indesit IF-88-K-GP.A-IX-S User Manual

Page 29

background image

GB

29

• All accessories - with the exception of the sliding racks

- can be washed like everyday crockery, and are even

dishwasher safe.

• We recommend that detergents are not sprayed directly

onto the control panel, but that a sponge is used instead.

! Never use steam cleaners or pressure cleaners on the

appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge and

a non-abrasive cleaning product, then dry thoroughly with a

soft cloth. Do not use rough abrasive material or sharp metal

scrapers as these could scratch the surface and cause the

glass to crack. For more thorough cleaning purposes, the

oven door may be removed:

1. Open the oven door fully (see

diagram);

2. Lift up and turn the small levers

located on the two hinges (see

diagram);

3. Grip the door on the two external

sides and close it approximately

half way. Pull the door towards you,

lifting it out of its slot (see diagram).

To replace the door, reverse this sequence.

Inspecting the seals

Check the door seals around the oven regularly. If the seals

are damaged, please contact your nearest Service Centre

(see Assistance). We recommend that the oven is not used

until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover

using a screwdriver.

2. Unscrew the light bulb

and replace it with a similar

one: Wattage 15 W, cap E 14.

Replace the glass cover,

making sure the seal is

positioned correctly (see

diagram).

! Do not use the oven lamp as/for ambient lighting.

AUTOMATIC CLEANING mode

During the AUTOMATIC CLEANING cycle, the internal

temperature of the oven reaches 500°C. The pyrolytic cycle

is activated, burning away food and grime residues. Dirt is

literally incinerated.

Keep children away from the appliance during the automatic

cleaning cycle as surfaces may become very hot. Particles

may ignite inside the oven as a result of the combustion

process. There is no cause for concern: this process is both

normal and hazard-free.

Before initiating the AUTOMATIC CLEANING mode:

• remove large or coarse food residues from the inside of

the oven using a damp sponge. Do not use detergents;

• remove all accessories and the sliding rack kit (where

present);

• Do not place tea towels or pot holders over the oven

handle.

• Turn the SELECTOR knob to the “0” position.

! If the oven is too hot, the pyrolytic cycle may not start. Wait

for the oven to cool down.

! The programme may only be started once the oven door

has been closed.

To activate the AUTOMATIC CLEANING cycle press and
hold the

button for approximately 4 seconds. The TIMER

KNOB may be used to select the desired cleaning level; there

are three default time settings which cannot be modified.

1. Economy (ECO): turn the knob towards “ ”. Duration 1

hour.

2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.

3. Intensive (INT): turn the knob towards “ ”. Duration 2

hours.
4. Press the

button to confirm.

An end time for the FAST CLEAN cycle (as for a normal

cooking cycle) may be programmed (see Programming the

automatic cleaning end time).

Glass door

Seal (only on a

few models)

Lamp

Oven

compartment