Installation, Positioning – Indesit TK64SIX User Manual

Page 13

Installation

Before operating your new appliance please read this

instruction booklet carefully. It contains important

information concerning the safe operation, installation

and maintenance of the appliance.

Please keep these operating instructions for future

reference. Pass them on to any new owners of the

appliance.

Positioning

Keep all packaging material out of the reach of

children. It may present a choking or suffocation hazard

(see Precautions and tips).

The appliance must be installed by a qualified

professional in accordance with the instructions

provided. Incorrect installation may damage property or

cause harm to people or animals.

Built-in appliance

Use an appropriate cabinet to ensure that the appliance

operates properly.

The supporting surface must be heat-resistant up

to a temperature of approximately 100°C.

If the appliance is to be installed above an oven,

the oven must have a forced ventilation cooling

system.

Avoid installing the hob above a dishwasher: if

this cannot be avoided, place a waterproof

separation device

between the two

appliances.

Depending on the

hob you want to install,

the cabinet must have

the following

dimensions (see

figure):

Ventilation

To allow adequate ventilation and to avoid overheating

of the surrounding surfaces the hob should be

positioned:

At a minimum of 40 mm from the back panel and

600 mm from any

other vertical

surfaces.

So that a

minimum distance

of 10 mm is

maintained

between the

installation cavity

and the cabinet

underneath.

Fixing

The appliance must be installed on a perfectly level

supporting surface.

Any deformities caused by improper fixing could alter

the features and the operation of the hob.

560 +/- 1

490 +/- 1

590

520

FRONT SIDE OF HOB

SUPPORTING

SURFACE

UNDERSIDE OF HOB

40 mm min.

40mm

Opening of at least 5 mm
on the overall width
measurement of the surface.

Above an empty cabinet or a drawer
A space of at least 40 mm, or an opening of 5 mm on
the width measurement of the cabinet, should be created.