Apple Xserve (Logic Board with Processor/Heatsink Replacement) - Manual (Page 6)

Xserve Logic Board with Processor/Heatsink - 6
2. Pull the clip on the riser forward to release the riser from the logic board connector.
(Figure 6)
3. Disconnect the riser from the logic board and remove the riser and card from the
server.
Figure 6
Heatsink Duct
1. Release the latch on the heatsink duct from its slot, slide the duct away from the
blower, and lift the end of the duct as shown. (Figure 7)
2. Remove the duct from the server.
Figure 7