Apple Xserve (Logic Board with Processor/Heatsink Replacement) - Manual (Page 12)

Xserve Logic Board with Processor/Heatsink - 12
12. Remove the battery insulator tab from the battery holder on the replacement logic
board. (Figure 14)
Figure 14
Note: Replacing the logic board in the server changes its Ethernet ID number. The new
number is printed on an Ethernet ID label packaged with the replacement logic board.
After installing the new logic board, cover the Ethernet ID number on the server’s back
panel with the new ID label.
Closing the Server
1. Carefully slide the bottom housing back into the rack.
2. Tighten the front thumb screws to secure it.
Warning: Never turn on the server unless all of its internal and external parts
are in place and it is closed. Operating the server when it is open or missing
parts can damage it or cause injury.