Nikon LS-2000 - Manual (Page 18)

8
3. Setup
Nikon LS-2000 35 mm Film Scanner User’s Guide
Step 3—Connect the power cable
Before connecting the power cable, confirm that the scanner is off
and that the transport locking screws have been removed from the
side of the scanner and adapter slot. The scanner is off when the
end of the power switch marked “0” is down.
Attach the female end of the power cable to the AC connector on
the rear of the scanner and insert the male end into a general-
purpose household outlet.
Safety Precautions
• Use an AC power supply of 50/60Hz and a voltage of from
100V–240V. Be sure to use a power cord rated for the appropri-
ate voltage.
At voltages of more than AC 125V:
use a power cord that complies with the safety standards of the
country in which it is used, which has a plug rated for AC 250V,
15A (NEMA 6P-15) and insulation of SVT type or better, and
which is more than AWG18 in thickness.
At voltages of AC 125V or less:
use a power cord that complies with the safety standards of the
country in which it is used, which has a plug rated for AC 125V,
10A and insulation of SVT type or better, and which is more
than AWG18 in thickness.
• Do not damage or modify the power cable. Fire or electric
shock may result if the cable is placed under heavy objects,
exposed to heat or flame, or forcibly tugged or bent.
Power switch off