Spektrum SPM9549 - Manual (Page 4)

EN
Hook Up
Installation and Hook Up Information
Installing the TM1100 Module
Mount the TM1100 module near the receiver in a position that allows the 2.5-inch data
lead to extend from the receiver’s Data port to the Data port on the telemetry module. You
can use servo tape to secure the TM1100 module or wrap it in foam with the receiver. Plug
the Data lead into the TM1100 port marked DATA and plug the other end of the lead into
the receiver’s DATA port.
NOTICE: Route and secure the antenna away from any metallic or conductive materials to
give the best range.
At this point the internal telemetry DATA is now fully functional. This includes:
• Flight log data (fades, frame losses and holds)
• Receiver pack voltage
Before continuing, bind the system to the transmitter and confirm the telemetry system is
functioning.
Bind Stylus
Data Port
with Data Lead
Temp/ Volt Port
with Y-Harness
Temperature Lead
Voltage Lead
RPM Port
Antenna
Optional RPM Sensor (nitro)
Optional Electric RPM Sensor
(not attached)
Bind Button