Spektrum SPM3160 DX3E - Manual (Page 6)

6 SPEKTRUM DX3E USER GUIDE
baTTery led monITor
A green LED battery monitor is located on the front left
of the transmitter next to the on/off switch. When the
battery voltage is above 5 volts the LED will be solid
green indicating that the battery has sufficient operational
voltage. Below 5 volts the green LED will begin to dim,
indicating the battery is low. When the voltage drops
below 4 volts, the green LED will turn off and only the
red LED will be lit, indicating the batteries should be
replaced immediately.
Solid Green - Battery is good
Dim Green - Battery voltage is low
No Green, only Solid Red - Battery voltage is critically
low. Replace batteries
oPTIonal rubber grIPs
The DX3E is supplied with a medium-size grip installed
on the transmitter. Optional small and large grips are
available (SPM9006) to fit preferences and hand sizes.
Each grip’s size is identified with an “S” (small), “M”
(medium), or “L” (large) on the inside of the grip for
easy identification. To remove, simply lift the edge of the
grip and continue around the grip until it is completely
removed. To replace, align the tabs of the grip to the slots
in the handle and press the grip in place.
reCeIver ComPaTIbIlITy
The DX3E features DSM technology and is compatible
with Spektrum DSM and DSM2 surface receivers and the
marine receiver.
ComPaTIble sPekTrum reCeIvers
The DX3E is compatible with the following receivers.
Note: The DX3E operates in 16.5ms frame rate.
DSM
SR300 - 3-channel Sport - SPMSR300
SR3001 - 3-channel Pro - SPM1205
SR3300T - 3-channel with built-in telemetry - SPMSR3300T
SR3500 - 3-channel Micro Race - SPM1210
Note: The SR3000HRS (SPM1202) receiver
is designed to be used with Spektrum’s Futaba
HRS compatible module system only and is
not compatible with the DX3E.
DSM2
SR3100 - 3-channel Pro - SPMSR3100
SR3520 - 3-channel Micro Pro - SPMSR3520
Marine
MR3000 - 3-channel Marine - SPMMR3000
Please note that DSM2 and marine compatible
transmitters can be identified by the following logo
located on the back of the transmitter:
EN