Spektrum SPM1014 - Manual (Page 12)

It’s necessary to program the receiver to a specific module so that the receiver will only
recognize that module, ignoring signals from any other sources. If the receiver is not
bound to a module, the system will not operate. Also during the binding process the servo
fail-safe positions are set.
It is only necessary to bind the receiver to the module during first installation and is
recommended when the receiver is moved from one vehicle to another. Receivers can
be re-bound to the same module or to other modules an infinite number of times. Also an
unlimited number of receivers can be bound to a single transmitter module, common when
using one transmitter to operate several models.
1. Make sure the transmitter and receiver are turned off.
2. With the receiver off, press and hold the bind button on
the receiver.
3. Turn on the receiver while holding the bind button.
4. Release the bind button when the LED flashes green.
Binding
Binding Process
1