Ask Proxima C200 (DP6500x) - Manual (Page 2)

Copyright © 1997-2004 InFocus Corporation.
All Rights Reserved.
Write Command Examples
Function Command Response
Brightness (BRT10) Sets the brightness to
10
Freeze (FRZ1) or (FRZ8888) Freezes the display
Power (PWR0) Turns power off
Power (PWR1) Turns power on
Error Conditions
Not all commands are supported for all projectors. If an unsupported command is issued, the command will be ignored. If a
command is received that is not understood, a ‘?’ character will be returned indicating the command was not understood.
Limitations
The CLI cannot respond to commands coming in at a high-rate. Therefore, a delay must occur between commands to ensure
that the command gets properly executed. To assure the projector can process a command, wait 3 seconds before entering
the next command.
Function Command Min Max Default Notes
Auto Power APO 0 1 0
Aspect Ratio
0 – Native 1 – 16:9 2 – 4:3
ARZ 0 2 2 S
Auto Source ASC 0 1 1
Balance
< 24 – softer right >24 – softer left
BAL 0 48 24
Blue Gain BCG 1 63 32 S
Brightness BRT 8 248 128 S
Blank Screen BSC 0 2 1
Blank BLK 0 1 -1 W
Ceiling CEL 0 1 0
Color CLR 8 248 128 S
Contrast CON 8` 248 128 S
Color Space
0 – RGB 1 – SMPTE240 2 – REC709 3 – REC601 7 – Auto
CSM 0 7 7 S, A
Keystone DKC 2 254 128
Display Messages DMG 0 1 1
Power-up Source DSC 0 4 0
Startup Logo 0 – Blank Screen 1 – Default DSU 0 1 1
Effect
0 – Blank 1 – Mute 2 – Aspect Ratio 3 – Source 4 – Auto Image 5 – Freeze 6
– Zoom 7 – About
EFK 0 8 8
Green Gain GCG 1 63 32