Agri-Fab 45-03621 - Manual (Page 8)

8
ASSEMBLY
INSTALL TOWBAR TUBE TO REAR
QUADRANT
• Place Towbar Tube into Rear Quadrant, align holes and
insert 3/8 x 2-3/4 Hex Bolt through quadrant and rear
hole of Tube.
• Secure tightly with 3/8 Hex Lock Nut and then loosen
1/4 turn to allow Tube to pivot freely inside Rear
Quadrant.
• Insert 3/8 X 2-3/4 Bolt and 3/8 Flat Washer into slot in
Rear Quadrant and into hole in Towbar Tube.
• Secure Tightly with 3/8 Flat Washer and 3/8 Hex Lock
Nut, then loosen 1/4 turn to allow Tube to pivot freely
inside Rear Quadrant.
NOTE: Towbar Tube must pivot freely inside Rear Quadrant
when Latch is pulled from notch.
INSTALL CLUTCH CABLE TO TOWBAR TUBE
• Place Clutch Cable forward along Towbar Tube.
• Spread ends of two Cable Clips and place around
Clutch Cable.
• Place Clutch Cable on top of Towbar Tube and align
Cable Clips with bolt holes in Towbar Tube.
• Secure with two #10 Screws.
INSTALL BATTERY
Your Trail Mower requires a 12 volt battery to operate. The
battery is NOT included with the unit. It must be purchased
separately.
• Remove four screws and the Battery Cover from the
Mower and set them aside.
• Install two Plastic Nuts into the square holes in the
Mower Deck under the Battery Cover.
• Place the Battery on the Mower Deck between the two
Plastic Nuts.
• Place the Battery Hold Down on top of the Battery.
• Secure the Battery to the Mower Deck with two
1/4 x 7-1/2 hex bolts.
• Open the terminal access doors on the Battery Hold
Down.
• Connect the Red Wire to the positive (+) battery terminal
using a 1/4 x 3/4 hex bolt and 1/4 SEMS nut. Tighten
securely.
• Connect the Black Wire to the negative (-) battery
terminal using a 1/4 x 3/4 hex bolt and 1/4 SEMS nut.
Tighten securely.
• Close the terminal access doors.
• Replace Battery Cover and secure it with the four
screws.
INSTALL CLUTCH CABLE TO CLUTCH LEVER
• Remove outer 5/16 Nut from end of Clutch Cable
Housing. (See Fig. 1)
• Turn inner 5/16 Nut to bottom of thread.
• Insert Cable and outer 5/16 Nut through slotted hole
in Cable Guide of Hitch Assembly. The outer 5/16 Nut
musts be cocked sideways to insert through slotted hole
of Cable Guide.
• Reinstall outer 5/16 Nut to the cable housing to secure
Cable Harness to Cable Guide.
• Install Mounting Anchor of Clutch Cable to Clutch Lever
using Clevis Pin and Hair Cotter Pin.