Blodgett BCH-E - Manual (Page 7)

7
ELECTRICAL CONNECTIONS
WARNING: Electrical and grounding connections must comply with the
applicable portions of the National Electrical Code and/or other local
codes.
WARNING: Disconnect the power supply to the appliance before cleaning
or servicing.
The wiring compartment is located behind the control panel. Refer to Page 4 Service
Connections.
1. Remove the wiring compartment cover and make electrical connections per the
wiring diagram located inside the control housing cover panel. The braising pan
must be grounded in accordance with requirements of the National Electrical Code or
applicable local codes. Connection from incoming lines must be waterproof.
2. Ground skillet to terminal provided in control housing. A wiring diagram is provided
and is located inside the control cover panel.
3. Replace wiring compartment cover.
SERVICE CONNECTIONS
All internal wiring for the skillet is complete.
Make service connections as indicated on page 4 and Electrical Connections above.
If faucet is provided connect water supply and check for proper operation.