Allied Telesis AT-8800 SERIES - Manual (Page 3)

3
SAFETY AND STATUTORY INFORMATION
!1
Safety
WARNING: In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
WARNING: Class 1 Laser product.
WARNING: Do not stare into the laser beam.
CAUTION: Use of controls or adjustments of performance or procedures other than
those specified herein may result in hazardous radiation exposure.
ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock , do not remove the cover. No user-serviceable parts inside.
This unit contains HAZARDOUS VOLTAGES and should only be opened by a trained
and qualified technician.
LIGHTNING DANGER
DANGER: DO NOT WORK on equipment or CABLES during periods of
LIGHTNING ACTIVITY.
CAUTION: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO
DE-ENERGIZE EQUIPMENT, disconnect the power cord.
ELECTRICAL - TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly
wired earth ground socket outlet. An improperly wired socket outlet could place
hazardous voltages on accessible metal parts.
PLUGGABLE EQUIPMENT, the socket outlet shall be installed near the equipment and
shall be easily accessible.
CAUTION: Air vents must not be blocked and must have free access to the room
ambient air for cooling.
OPERATING TEMPERATURE: This product is designed for a maximum ambient
temperature of 40 degrees C.
ALL COUNTRIES: Install product in accordance with local and
National Electrical Codes.
WARNING: For centralized DC power connection, install only in a restricted
access area.
A tray cable is required to connect the power source if the unit is powered by centralized
DC power. The tray cable must be UL listed Type TC tray cable and rated at 600 V and 90
degree C, with three conductors, minimum 14 AWG.
WARNING: Only trained and qualified personnel are allowed to install or replace
this equipment.