Allied Telesis SwitchBlade Bandwidth Expander - Manual (Page 6)

6 SwitchBlade Bandwidth Expander
C613-04041-01 REV A
Figure 3: Ejector lever and locking slot.
6. Secure the bandwidth expander
Move the ejector levers to the locked position and tighten the expander’s
two Phillips screws (see Figure 1 on page -5).
7. Verify the installation
Use the SHOW SYSTEM command to verify that the switch has recognised
the bandwidth expander. If there is no bandwidth expander entry in the
output, recognition has failed.
If recognition fails, repeat the installation process, paying particular
attention to steps 5 and 6.
If the reinstallation fails, see the SwitchBlade Hardware Reference, which has
further troubleshooting information.
Where To Find More Information
Sources of further information:
■ The Documentation and Tools CD-ROM, bundled with every switch
controller and every chassis, contains the complete Documentation Set for
your switch and its expansion options, as well as tools for managing the
switch.
■ The SwitchBlade Safety and Statutory Information Booklet provides safety and
statutory information for the SwitchBlade and its accessories.
■ The SwitchBlade Hardware Reference provides detailed information on the
switch and its hardware features.
■ The SwitchBlade Software Reference provides detailed information on
configuring the switch and its software.
■ The SwitchBlade Power Supply Unit Quick Install Guide outlines the
procedure for installing AC and DC power supply units.
■ The SwitchBlade Switch Controller Quick Install Guide outlines the procedure
for installing switch controllers.
■ The SwitchBlade Chassis and Fan Tray Quick Install Guide outlines the
procedure for installing chassis and fan trays.
■ The CAM Quick Install Guide outlines the procedure for installing Content
Addressable Memory.
■ www.alliedtelesyn.co.nz/support/switchblade/