AEG L 98485 FL - Manual (Page 34)

Problem Possible cause Possible solution
You did not remove the
packaging and/or the
transit bolts. Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
The load is very small. Add more laundry in the drum.
The appliance fills
with water and
drain immediate-
ly. The end of the drain
hose is too low. Make sure that the drain hose is
in the correct position.
The washing re-
sults are not satis-
factory. The detergent you used
was not sufficient or cor-
rect. Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry. Use special products to remove
the stubborn stains.
You set a not correct
temperature. Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
The internal lamp
is off. The lamp is burned. To replace the lamp, contact the
service centre.
After a steam
programme, gar-
ments are partial-
ly wet. The appliance is not ac-
curately levelled. Check the levelling and adjust
the appliance by raising or lower-
ing the feet.
After a steam
programme, gar-
ments are not suf-
ficiently smooth. A wrong STEAM pro-
gramme has been selec-
ted (e.g. Synthetic in-
stead of Cotton). Note the composition of the fab-
ric.
Excessive laundry load. Reduce the laundry load
The drum is emp-
ty and the display
shows there is
some weight in . It is necessary to set a
tare. Press button 1 to deactivate
the appliance and to activate it
again.
The drum is full
but the display
shows 0.0 kg. You loaded the laundry
before to activate the
appliance. Press button 1 to deactivate
the appliance . Empty the drum
and obey to the necessary steps.
(Refer to 'Loading the laundy')
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm message,
contact the service centre.
34