AEG L 98485 FL - Manual (Page 32)

TROUBLESHOOTING
The start of the appliance does not occur
or it stops during operation.
Try to find a solution to the problem be-
fore you contact the service centre (refer
to the table).
With some problems, the acoustic sig-
nals operate and the display shows an
alarm message. WARNING!
Deactivate the appliance before
you do the checks.
Problem Possible cause Possible solution
The display tells
to check the tap:
the appliance
does not fill with
water. The water tap is closed. Open the water tap.
The water inlet hose is
damaged. Make sure that the water inlet
hose has no damages.
The filters in the water in-
let hose is blocked . Clean the filters. Refer to 'Care
and cleaning'.
The connection of the
water inlet hose is not
correct. Make sure that the connection is
correct.
The water pressure is too
low. Contact your local water authori-
ty.
The water tap is blocked
or is furred with lime-
scale. Clean the water tap.
The display tells
to check the
drain filter: the
appliance does
not drain the wa-
ter. The water drain hose is
damaged. Make sure that the water drain
hose has no damages.
The filter of the drain
pump is blocked. Clean the filter of the drain
pump. Refer to 'Care and clean-
ing'.
The connection of the
water drain hose is not
correct. Make sure that the connection is
correct.
The display tells
to check the
door. The appliance door is
open or not closed cor-
rectly. Close the door correctly.
The display tells
there is a water
alert. The anti-flood device is
activated. • Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
32