Abocom FVR206 - Manual (Page 6)

- 5 -
Quick Setup
WebUI Configuration example
STEP 1:
Connect both the Administrator’s PC and the Internal (LAN) port of the
Firewall VPN Router Firewall to a hub or switch. Make sure there is a link light
on the hub/switch for both connections. The Firewall VPN Router has an
embedded web server used for management and configuration. Use a web
browser to display the configurations of the firewall (such as Internet Explorer
4(or above) or Netscape 4.0(or above) with full java script support). The
default IP address of the firewall is 192.168.1.1 with a subnet mask of
255.255.255.0. Therefore, the IP address of the Administrator PC must be in
the range between 192.168.1.2 /24– 192.168.1.254/24.
If the company’s internal IP Address is not subnet of 192.168.1.0, (i.e.
Internal IP Address is 172.16.0.1) the Administrator must change his/her PC
IP address to be within the same range of the internal subnet (i.e.
192.168.0.0). Reboot the PC if necessary.
By default, the Firewall VPN Router is shipped with its DHCP Server function
enabled. This means the client computers on the internal (LAN) network
including the Administrator PC can set their TCP/IP settings to automatically
obtain an IP address from the Firewall VPN Router.
The following table is a list of private IP addresses. These addresses may
not be used as an External IP address.
10.0.0.0 ~ 10.255.255.255
172.16.0.0 ~ 172.31.255.255
192.168.0.0 ~ 192.168.255.255