Advantech PCM-9588 User Manual
Page 34
PCM-9588 User Manual
24
!
First / Second / Third / Other Boot Drive
!
Boot Up Floppy Seek [Disabled]
When enabled, the BIOS will seek the floppy “A” drive one time.
!
Boot Up NumLock Status [Disabled]
This item enables users to activate the Number Lock function upon system
boot.
!
Boot Up NumLock Status[Enabled]
This item enables users to activate the Number Lock function upon system boot
!
Gate A20 Option [Fast]
This item enables users to switch A20 control by port 92 or not.
!
Typematic Rate Setting
This item enables users to set the two typematic controls items.
This field controls the speed at
–
Typematic Rate (Chars/Sec)
This item controls the speed at which the system auto-repeats keystrokes.
Eight settings are 6, 8, 10, 12, 15, 20, 24 and 30.
–
Typematic Delay (Msec)
This item sets the keypress time interval before auto-repeat begins. The
delay rate options are 250, 500, 750 and 1000.
!
Security Option [Setup]
!
APIC Mode [Enabled]
This item allows user to enabled of disabled "Advanced Programmable Interrupt
Controller". APIC is implemented in the motherboard and must be supported by
the operating system, and it extends the number of IRQ's available.
!
MPS Version Control for OS [1.4]
This item sets the operating system multiprocessor support version.
!
OS Select For DRAM > 64 M [Non-OS2]
Select OS2 only if system is running OS/2 operation system with greater than
64 MB of RAM on the system.
Floppy
Assign this boot device priority to Floppy.
LS120
Assign this boot device priority to LS120.
Hard Disk
Assign this boot device priority to Hard Disk.
CDROM
Assign this boot device priority to CDROM.
ZIP
Assign this boot device priority to ZIP.
USB-FDD
Assign this boot device priority to USB-FDD.
USB-ZIP
Assign this boot device priority to USB-ZIP.
USB-CDROM
Assign this boot device priority to USB-CDROM.
USB-HDD
Assign this boot device priority to USB-HDD.
LAN
Assign this boot device priority to LAN.
Disabled
Disable this boot function.
System
System requires password both for bootup and for access to the
Setup page..
Setup
System requires password only for access to the Setup page, not for
bootup. (Default value)