Avanti DE 2402 SC - Manual (Page 14)

14
ቤ
PROBLEMS ON STARTING AND DURING THE SELF CLEANING CYCLE
1.
Steady door
The function selector has been turned to the self cleaning position with the oven door
open or not perfectly closed. Or the door has been opened before the cycle has been
started with confirmation from key 3
What to do:
Close the door and repeat previous cycle.
.
If after 5 minutes the door has not been closed door flashes and an audible sig-
nal sounds for 30”.
What to do:
Close the door, press any programmer key to silence the audible signal and repeat the
operations to start the cycle.
2. door with AUTO flashing
The oven door has been opened after the self cleaning cycle has started (before lock-
ing the door). The self cleaning cycle is zeroed.
What to do:
1. Close the door.
P0•00 appears on the electronic programmer display with the letter
P and AUTO flashing.
2. Turn the function selector to OFF and repeat the operations to start the cycle.
. If after 5 minutes the door has not been closed door flashes and an audible sig-
nal sounds for 30”.
What to do:
Close the door, press any programmer key to silence the audible signal and repeat the
operations to start the cycle.
3. F0.00 with AUTO flashing
The self cleaning cycle has been stopped and then started again when it was quite
a way through. The message is displayed after about 10 minutes and the self clean-
ing cycle is zeroed.
What to do:
1. Put the switch to
OFF .
2. Wait for at least 15 minutes.
3. Repeat the operations to start the self cleaning cycle.
4. If after several attempts the message continues contact the AVANTI Service Centre.
Caution: It is advisable not to stop the self cleaning cycle and then start it again
when it is quite a way through.
I I I I I I I
I
I
I
I I I I I I I I I I I I I I
I
I
I I I I I I
I
I I I
I
I
I II I
I
I I I I I I I I
I
I
I
I I I I I I I I I I I I I I
I
I
I
I I I I I I
I
I I I
I
I
I
II I
I
I
I I I
I
I
I
II
I
I