Installing batteries in the remote control, Switching on and off, Placing your television in standby mode – Samsung LE26R87BD User Manual
Page 10
english -
1. Lift the cover at the back of the remote control upward as shown in the
figure.
2. Install two AAA size batteries.
Make sure to match the "+" and "–" ends of the batteries with the
diagram inside the compartment.
. Replace the cover.
Remove the batteries and store them in a cool, dry place if you won’t be
using the remote control for a long time. The remote control can be used
up to about 23 feet from the TV.
(Assuming typical TV usage, the batteries last for about one year.)
If the remote control doesn’t work, check the following:
1. Is the TV power on?
2. Are the plus and minus ends of the batteries reversed?
3. Are the batteries drained?
4. Is there a power outage, or is the power cord unplugged?
5. Is there a special fluorescent light or neon sign nearby?
Installing Batteries in the remote Control
Switching on and off
the mains lead is attached to the rear of your set.
1. Plug the mains lead into an appropriate socket.
The standby indicator lights up on the front of the set.
2. Press the button on the front of the set.
You also can press the
PoWer button or the tV/DtV button on the remote control to turn
the TV on.
The programme that you were watching last is reselected automatically.
. Press the numeric button (0~9) or channel up/down ( / ) button on the remote control or
button on the right side of the set.
When you switch the set on for the very first time, you will be asked to choose language in
which the menus are to be displayed.
. To switch your set off, press the PoWer button again.
Your set can be placed in standby mode in order to reduce the power consumption. the standby
mode can be useful when you wish to interrupt viewing temporarily (during a meal, for example).
1. Press the PoWer button on the remote control.
The screen is turned off and a red standby indicator appears on the front of your set.
2. To switch your set back on, simply press the PoWer , numeric buttons (0~9), tV/DtV button or
channel up/down ( / ) button again.
Do not leave your set in standby mode for long periods of time (when you are away on holiday, for
example).
It is best to unplug the set from the mains and aerial.
Placing Your television in Standby mode
BN68-01169F-Eng-0313.indd 8
2007-03-13 �� 7:48:23