Samsung WF501ANW-XAA - Manual (Page 2)

ALIGNMENT AND ADJUSTMENTS
2
GENERAL ERROR FUNCTION
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
1 nd
The water level fails to drop below the
Reset Water Level within 15 minutes.
Go to “ Will Not Drain” Troubleshooting
Section.
2 Lo Door fails to Unlock After 7 attempts. Go to “ Will Not Unlock”
Troubleshooting Section.
3 nF
When the filling Continues for more
than 40 minutes or there is no change
of water level for 6 minutes.
Go to “ No Water Fill” Troubleshooting
Section.
4 FL Door fails to lock after 7 attempts.
Go to “ Will Not Lock” Troubleshooting
Section.
5 LE
A water level lower than the Reset
water level is detected for 5 seconds
during the Wash/Rinse cycle.
Go to “No Water Fill” Troubleshooting
Section.
6 1E Water level sensor problem.
GO yo “NO Water Fill” Troubleshooting
section
7 dL
Door is unlocked when washer is
running.
Press the Power button to turn off
your washer, then restart the cycle. If
the code reappears, call for service.
8 OE
A fault is detected in the water level
sensor. Data (frequency) shows the
water level is at or above the overflow
water level. (When this condition is
detected, the machine will automatically
starts draining water until the water
level falls below the reset water level)
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level.
9 dc
Unbalance or cabinet bump is detected
during final spin, which prevents the
drum from spinning over 150 rpm. (Never
exceeds 150 RPM due to unbalanced load)
Go to “Wet Clothes” Troubleshooting
Section.
10 E2
Jammed Key.(When key input signals
are coming out for more than 30
seconds, it is regarded as a jam.)
Check all of keys. If A key is sensed
to be pressed, all keys will do not
respond.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
(Technical information)WF501ANWX-03011B_EN.indd 2 2011-06-24 �� 6:20:23