Maintaining your appliance, Self-cleaning, Before a self-cleaning cycle – Samsung FE710DRS-XAA User Manual
Page 56
56_ Maintaining your appliance
maintaining your appliance
SELF-CLEANING
This self-cleaning oven uses high temperatures (well above cooking temperatures) to burn off
leftover grease and residue completely or reduce them to a finely powdered ash that you can wipe
away with a damp cloth.
• During the self-cleaning cycle, the outside of the range will become very hot to the
touch. Do not leave small children unattended near the appliance.
• Some birds is extremely sensitive to the fumes given off during the self-cleaning cycle
of any range. Move birds to another well-ventilated room.
• Do not line the oven walls, racks, bottom or any other part of the range with
aluminum foil. Doing so will result in poor heat distribution, produce poor baking
results and cause permanent damage to the oven interior (aluminum foil will melt and
stick to the interior surface of the oven).
• Do not force the oven door open while self-cleaning is in progress. This can damage
the automatic door locking system. Use care when opening the oven door after the
self-cleaning cycle is complete. Stand to the side of the oven when opening the door
to allow hot air or steam to escape. The oven may still be VERY HOT.
Before a self-cleaning cycle
Fig. 1
• We recommend venting your kitchen with an open window
or using a ventilation fan or hood during the self-cleaning
cycle.
• Remove the wire rack, broil pan, broil pan insert, all
cookware and any aluminum foil from the oven.
• Wipe up debris from the oven bottom. (Fig. 1)
• The silver-colored oven racks can be self-cleaned, but they
will darken, lose their luster and become hard to slide.
• Residue on the front frame of the range and outside the
gasket on the door will need to be cleaned by hand. Clean
these areas with hot water, soap-filled steel-wool pads or
cleansers such as Soft Scrub. Rinse well with clean water
and dry.
• Do not clean the gasket. The fiberglass material of the oven
door gasket cannot withstand abrasion. It is essential for
the gasket to remain intact. If you notice it becoming worn
or frayed, replace it. (Fig. 2)
• Make sure the oven light bulb cover is in place and the
oven light is off.
Don’t hand
clean the
oven door
gasket.
Fig. 2
You may
hand clean
the door.
CAUTION
FE710DRS_XAA_DG68-00333A-07.indd 56
31/10/2012 17:31:29