Samsung FE710DRS-XAA - Manual (Page 53)

Operating the oven _53
OPERA
TING THE O
VEN
Convection auto conversion feature
When you use convection bake, the convection auto conversion feature will automatically convert
entered regular baking temperatures to convection baking temperatures.
This feature is activated so that the display will show the actual converted (reduced) temperature.
For example, if you enter a regular recipe temperature of 350 °F and press the START/SET pad,
the display will show the converted temperature of 325 °F.
How to disable or enable the auto conversion feature
1. Press CONV. BAKE and the 0 number pad at the same time for 3
seconds.
The display will show Con On (enabled) or Con OFF (disabled).
The default setting is Con On.
2. Press the 0 number pad to select Con On or Con OFF.
Pressing the 0 number pad changes the mode between Con On
and Con OFF.
3. Press the START/SET pad.
Thermostat adjustment
The temperature in the oven has been preset at the factory. When first using the oven, be sure to
follow recipe times and temperatures. If you think the oven is too hot or too cool, you can adjust
the temperature in the oven. Before adjusting, test a recipe by using a temperature setting that is
higher or lower than the recommended temperature. The baking results should help you to decide
how much of an adjustment is needed.
The oven temperature can be adjusted ±35 °F (±19 °C ).
How to adjust the oven temperature
1. Press BAKE and the 0 number pad at the same time for 3
seconds.
The display will show AdJ 0.
2. Enter the adjustment you want, eg. 20 °F, by using the number
pads.
You can adjust the temperature to lower than the factory setting by
pressing the BAKE pad.
3. Press the START/SET pad.
This adjustment will not affect the broiling or the self-cleaning temperatures. The adjustment
will be retained in memory after a power failure.
FE710DRS_XAA_DG68-00333A-07.indd 53 31/10/2012 17:31:28