Samsung WA56H9000AP-A2 - Manual (Page 30)

English - 30
troubleshooting
cHeck tHese solutions if your WAsHer…
problem soluTion
Will not start. • Make sure the lid is closed.
• Make sure your washer is plugged in.
• Make sure the water source faucets are open.
• Make sure to press the Start/Pause button to start your Washer.
• Make sure Child Lock is not activated. See page 20.
• Before your washer starts to fill, it will make a series of clicking noises
to check the lid lock and do a quick drain.
• Check the fuse or reset the circuit breaker.
Has no water or not enough
water.
• Turn both faucets on fully.
• Straighten the water inlet hoses.
• Disconnect hoses and clean the screens. Hose filter screens may be
clogged.
• You use the optimum water required for cleaning, but if you use the
Niagara Wash cycle, you are using more water than compared to the
Normal cycle. The cycle then proceeds to the Normal cleaning and
rinse levels.
Has detergent remaining
in the automatic dispenser
after the wash cycle is
complete.
• Make sure your washer is running with sufficient water pressure.
vibrates or is too noisy. • Make sure your washer is set on a level surface. If the surface is not
level, adjust your washer’s feet to level the appliance.
• Make sure your washer is not touching any other object.
• Make sure the laundry load is balanced.
stops • Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the lid and press the Start/Pause button to start your washer.
For your safety, your washer will not spin unless the lid is closed.
• Before your washer starts to fill, it will make a series of clicking noises
to check the lid lock and do a quick drain.
• There may be a pause or soak period in the cycle. Wait and it may
start.
• Check the screens on the inlet hoses at the faucets for obstructions.
Clean the screens periodically.
9000HA WASH_WA56H_USER MANUAL_DC68-03133R_EN.indd 30 2014-1-23 17:01:35