Samsung WA50F9A7DSP-A2 - Manual (Page 3)

ALIGNMENT AND ADJUSTMENTS
3
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
12
The hot/cold water hose connection
is not correct.
Please connect the hot/cold water
hose connection correctly.
13
Suds is detected during the washing
session. (“SUd” or “Sd” is not an error.
When it finishes washing, End and
the “SUd” or “Sd” code will blink in
turn.)
Guide a user to reduce amount of
detergent usage.
14
Communication error between SUB
PBA and MAIN PBA
Check Main PBA, SUB PBA & Wire-
harness. Replace PCB
15
If the MEMS communication error or
MEMS trouble diagnosis error occur,
this message will be displayed.
1. Check the MEMS sensor and PBA.
2. Check the wire connector
terminals
16
A button except the Power button is
continually pressed.
Check whether either the Power
switch or a tact switch is continually
pressed
17
The hot/cold water hose connection
is not correct.
Please connect the hot/cold water
hose connection correctly.
18
(Clutch Motor Error)
This error occurs when the position
of the clutch is not detected.
- If the position detection signal is
not received 15 seconds after the
clutch motor starts, the spin drum is
shaken left and right and then the
motor is restarted.
If the motor position signal is not
received even after 3 reattempts, a
PE error occurs.
1. Check the clutch motor.
2. Check the assembly status of the
clutch motor.
3. Check the wire connector
terminals.
19
(clutch hall sensor
error)
After the completion of the clutch
position detection, and the clutch
hall signal is invalid, the spin drum
is shaken left and right and then the
clutch hall signal is evaluated again.
This, if the clutch hall signal is still
invalid, the clutch position switching
status is checked and then the
operation is restarted.
(If the 15 reattempts fail, this error
occurs.)
1. Check the clutch hall sensor.
2. Check the wire connector
terminals.
3. Check the clutch switching status.
- Check the coupling assembly and
disassembly status.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
F900A WASH_WA50F_ MANUAL_DC68-03132C_EN（需要翻译的文件）.indd 3 2013-1-21 14:58:13