Samsung WA50F9A7DSP-A2 - Manual (Page 2)

ALIGNMENT AND ADJUSTMENTS
2
GENERAL ERROR FUNCTION
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
1
The water level fails to drop below
the Reset Water Level within 30
minutes.
Go to “ Will Not Drain”
Troubleshooting Section.
2 Door fails to Unlock After 7 attempts. Go to “ Will Not Unlock”
Troubleshooting Section.
3
When the filling Continues for
more than 60 minutes or there is no
change of water level for 5 minutes.
Go to “ No Water Fill”
Troubleshooting Section.
4 Door fails to lock after 7 attempts.
Go to “ Will Not Lock”
Troubleshooting Section.
5
A water level lower than the Reset
water level is detected for 5 seconds
during the Wash/Rinse cycle.
Go to “No Water Fill” Troubleshooting
Section.
6
Water Level Sensor Trouble. (When
the input signal from the water level
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
Go to “No Water Fill”
Troubleshooting Section
7
A fault is detected in the water level
sensor. Data (frequency) shows
the water level is at or above the
overflow water level. (When this
condition is detected, the machine
will automatically starts draining
water until the water level falls
below the reset water level)
First check to see that all of water
valves are not stuck. If water valves
are OK, check water level.
8
Unbalance or cabinet bump is
detected during final spin
Go to “Wet Clothes” Troubleshooting
Section.
9
Door is detected as open while it is
trying to lock the door.
Go to “Quick Test Mode” and then do
Door Lock/Unlock Test
10
This occurs when the water
temperature sensor fault is detected
continuously for 5 seconds.
Go to “ Board Input Test” and check
Water Temperature. Check loose
or pinched wires. Replace PCB or
thermistor.
11
MICOM is attempting to drive the motor
but is not getting any response signals
from the hall sensor. Visual check shows
motor is not running. (Locked, Defective
Hall Sensor or Overload)
Evaluate wire harness for loose or
unhooked connections. Go to “
Quick Test Mode” and test Motor.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
F900A WASH_WA50F_ MANUAL_DC68-03132C_EN（需要翻译的文件）.indd 2 2013-1-21 14:58:12