Samsung LNR2050PX-XAA - Manual (Page 9)

English-7
Plug and Play Feature
When the TV is initially powered on, several basic settings proceed automatically and subsequently.
The following settings are available.
1. Press the POWER button on the remote control.
The message “Start Plug & Play” is displayed with “OK” selected.
2. Select the appropriate language by pressing the or button.
Press the ENTER button to confirm your choice.
3. The message “Check antenna input.” is displayed with “OK” selected.
Press the ENTER
button.
Please check that the antenna cable is connected correctly.
4. Press the or button to select “Air”, “STD”, “HRC”, or “IRC”, then press the ENTER button.
5. Press the ENTER button to select “Start”.
The channel search will start and end automatically.
After all the available channels are stored, the “Clock Set” menu appears.
Press the ENTER button at any time to interrupt the memorization process.
6. Press the ENTER button.
Press the or button to move to the “Hour”, “Minute” or “am/pm”.
Set the “Hour”, “Minute” or “am/pm” by pressing the or button.
7. Press the ENTER button to confirm your setting.
The message “Enjoy your watching.” is displayed.
If you want to reset this feature...
1. Press the MENU button to display the menu.
Press the
or button to select “Setup”, then press the ENTER button.
2. Press the or button to select “Plug & Play”, then press the ENTER button.
3. This will change or reset the settings.
Language: Select your language.
Air/Cable: Select your local cable company TV system.
Auto Program: Selects between terrestrial antenna connection or your local cable company TV system.
The TV automatically cycles through all of the available channels and stores them in memory.
This takes about one to two minutes.
Clock Set: Sets the current time for the TV clock.
You can also set the hour and minute by pressing the number buttons on the remote control.
Viewing the Display
The on-screen displays disappear after about ten seconds.
Press the button once more or wait approximately 10 seconds and it disappears automatically.
Press the INFO button on the remote control to view current channel and the status of certain audio-video settings.
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is
connected to the TV (i.e. an antenna or a cable system).
1. Press the MENU button to display the menu.
Press the
or button to select “Channel”, then press the ENTER button.
2. Press the ENTER button to select “Air/Cable”.
3. Press the or button to select the Video signal source, then press the ENTER button.
4. Press the EXIT button to exit.
STD, HRC and IRC identify various types of cable TV systems.
Contact your local cable company to identify the type of cable system that exists in your particular area.
At this point, the signal source has been selected. Proceed to “Storing Channels Automatically”.