AEG 56740 - Manual (Page 24)

All the cycles have to be checked in accordance with EN 61121 (Tumble dryers for household
use – Methods for measuring the performance).
Installation
Appliance positioning
• It is recommended that, for your convenience, the machine is positioned close to your
washing machine.
• The tumble dryer must be installed in a clean place, where dirt does not build up.
• Air must be able to circulate freely all round the appliance. Do not obstruct the front
ventilation grille or the air intake grilles at the back of the machine.
• To keep vibration and noise to a minimum when the dryer is in use, it should be placed
on a firm, level surface.
• Once in its permanent operating position, check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or lower the feet until it is.
• The feet must never be removed. Do not restrict the floor clearance through deeppile
carpets, strips of wood or similar. This might cause heat built-up which would interfere
with the operation of the appliance.
The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance
must therefore not be installed on floors which are not resistant to high temperatures.
When operating the tumble dryer, the room temperature must not be lower than +5°C and
higher than +35°C, as it may affect the performance of the appliance.
WARNING!
Should the appliance be moved, it must be transported vertically.
WARNING!
The appliance must not be installed behind the lockable door, a sliding door or a door with
a hinge on the opposite side to that of the appliance.
Removing transport safety packaging
CAUTION!
Before use all parts of the transport packaging
must be removed.
1. Open loading door
2. Pull off adhesive strips from inside machine
on top of drum.
24 Installation