AEG 56740 - Manual (Page 22)

Machine settings
Setting Implementation
BUZZER permanent off 1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE and LONG ANTI-
CREASE buttons and hold down for approx. 5 sec-
onds.
3. The buzzer is by default always off. You can use BUZ-
ZER button to activate or deactivate sound but ma-
chine does not memorize your selection.
Water hardness
Water contains, a variable quantity of
limestone and mineral salts of which
quantities vary according to geograph-
ical locations thus varying its conduc-
tivity values.
Relevant variations of the conductivity
of the water compared to those prefixed
by the factory could slightly influence
the residual humidity of the laundry at
the end of the cycle. Your dryer allows
you to regulate the sensitivity of the
drying sensor based on conductivity
values of the water.
1. Turn the programme selector to any programme.
2. Press simultaneously the DELICATE and TIME buttons
and hold down for approx. 5 seconds. The current
setting is on the display:
– low conductivity <300 micro S/cm
– medium conductivity 300-600 micro S/
cm
– high conductivity >600 micro S/cm
3. Press the START PAUSE button sequentially until you
set desired level.
4. To memorize setting press simultaneously the DELI-
CATE and TIME buttons or turn knob to OFF position
Emptying water tank - warning mes-
sage permanent off
When using an external drain for the
condensed water.
1. Turn the programme selector to any programme.
2. Press simultaneously the LONG ANTI-CREASE and
TIME buttons and hold down for approx. 5 seconds.
The current setting is on the display:
–
- led warning is permanently off
– - led warning is activated
By default the warning led is activated and is lighting
always at the end of the drying cycle or during the cycle
if the water container is full.
22 Machine settings