Samsung UN46B7100WFUZA - Manual (Page 15)

English - 1
CHANNEL
You can configure various settings for your TV channels with features such as Auto Program, Favorite Channels, and Signal
Strength.
Channel Menu
Antenna → Air / Cable
Before your television can begin memorizing the available channels, you must specify the type
of signal source that is connected to the TV (i.e. an Air or a Cable system).
Press the TOOLS button to display the Tools menu. You can also set the Antenna by
selecting Tools → Switch to Cable (or Switch to Air).
Auto Program
Air: Air antenna signal. / Cable: Cable antenna signal. / Auto: Air and Cable antenna
signals
When selecting the Cable TV system: Selects the cable system. STD, HRC and IRC identify various types of cable TV
systems. Contact your local cable company to identify the type of cable system that exists in your particular area. At this point
the signal source has been selected.
After all the available channels are stored, it starts to remove scrambled channels (Removing scrambled channel). The Auto
program menu then reappears.
If you want to stop Auto Programming, press the
ENTERE button. The Stop Auto Program? message will be displayed.
Select Yes by pressing the ◄ or ► button, then press the ENTERE button.
Clear Scrambled Channel (digital channels only)
This function is used to filter out scrambled channels after Auto Program is completed. This process may take up to 20~30
minutes.
To stop searching scrambled channels: Press the ENTERE button to select Stop. Press the ◄ button to select Yes, then
press the ENTERE button.
This function is only available in Cable mode.
Channel List
For detailed procedures on using the Channel List, refer to the ‘Managing Channels’ instructions. (see pages 14~15)
You can select these options by simply pressing the CH LIST button on the remote control.
Fine Tune (analog channels only)
Use fine tuning to manually adjust a particular channel for optimal reception.
If you do not store the fine-tuned channel in memory, adjustments are not saved.
‘*’ will appear next to the name of fine-tuned channels.
To reset the fine tuning setting, press the ▼ button to select
Reset, then press the ENTERE button.
¦
❑
T
❑
■
N
N
N
❑
N
N
❑
O
❑
N
N
N
Antenna : Air ▶
Auto Program
Clear Scrambled Channel
Channel List
Fine Tune
Channel
[7000-NA]BN68-01988H-Eng.indb 13 2009-03-31 �� 8:10:45