Samsung AW25ECB8XAA - Manual (Page 10)

E-
10
Removing Excess Humidity
Remote Control Control Panel
If the temperature is not displayed on the control panel:
XPress the button on the Remote control
or
XPress the button on the unit one or more times until is displayed.
Result: XThe unit beeps each time you press the / button.
XThe Air Conditioner starts up in Cool mode.
±
You can change modes at any time.
2
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1 If necessary, press the (On/Off) button.
Result: X The Air Conditioner starts up in Cool mode.
X The unit beeps.
The Air Conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
X Plugged in
X Stopped
It will begin to cool after three minutes.
3 To adjust the temperature, press the
or buttons one or
more times until the desired temperature is displayed.
The temperature can be set between 64°F and 86°F.
Result:
X Each time you press the or buttons:
- The temperature is adjusted by 1°F
- The unit beeps
X The Air Conditioner starts removing the excess humidity;
the quality of air is adjusted automatically.
4 To control the direction of the air flow, refer to page 11.