Using the battery pack, Battery level display – Samsung DVD-L300-XAA User Manual
Page 14
27
ENGLISH
26
ENGLISH
Battery level display
• The battery level display indicates the amount of power remaining in the battery pack.
a. Fully charged
b. 20~40% used
c. 40~80% used
d. Completely used (flickers)
(If the battery mark flickers the DVD will turn off soon. Change the battery as soon as possible)
✽
The playing time is affected by environmental temperature and conditions.
The playing time becomes very short in a cold environment. The continuous playing times in the operating instructions are
measured using a fully charged battery pack at 77°F(25°C). As the environmental temperature and conditions may differ
when you actually use the DVD, the remaining battery time may not be the same as the approximate continuous
playing time given in these instructions.
NOTE:
NOTE:
• When the operation time is noticeably shorter than normal, it is time to buy a new battery.
The battery level display time changes depending on the battery operating time.
• As the battery is completely used, the noise screen intermittently can be displayed.
...........................a
...........................b
...........................c
...........................d
ENGLISH
Using the battery pack
Important!
• When inserting the battery pack, make sure that it is inserted correctly.
Otherwise, your DVD player may malfunction.
Use the AC adapter (included) to charge the battery pack.
• Before charging, make sure that the battery pack is correctly seated.
1. Connect the AC cord to the jack on the AC adapter ( ).
2. Connect the DC cord to the DC IN jack on the left side of the DVD player ( ).
3. Plug the other end of the AC cord into an AC outlet ( ).
Charging the battery pack
Power Charge Lamp
-Green light will flash while charging.
-When the battery pack is fully charged, the light will stop blinking and remain green.
Blinking time
Charging rate
Once per second
Less than 50%
Twice per second
50%~75%
Three times per second
75%~90%
Blinking stops and stays on
90%~100%
On for a second and
Error-Reset the battery pack and
off for a second
the DC cable
2
1
3
1
2
3