Nilfisk-ALTO CLE2.0 - Manual (Page 10)

23. AC Inlet
This connector is meant for the connection of the supplied main cord. Do not insert power cord into unit until
voltage has been correctly set. Do not plug power cord into AC power until voltage has been correctly set.
The fuse-holder above the AC connector on the rear of the chassis has 3 triangular markers(please refer to the above
pictures), with two of these triangles opposing each other, your unit is set to the operating voltage printed next to these
markers.
To change, pull fuse-holder out and rotate 180 , then push in again.
THIS IS SET FOR
110V AC TO 120V
AC OPERATION
THIS IS SET FOR
220V AC TO 240V
AC OPERATION
22. Fuse holder / Voltage elector S
This is a dual voltage unit. Before you attempt to connect and operate the unit, please make sure that your local
voltage matches the voltage on the fuse-holder cover.
Caution: The fuse protecting the AC supplies circuits of this unit. The fuse can only be changed by a qualified
technician, in the event of a fault or changing the supply voltage. If the fuse continues to blow after replacing,
discontinue use of this unit before repaired.
220-240V
110-120V
110-120V
220-240V
3.4 Connectors on The Rear Panel
Pic. 5 The Rear Panel of The CLE 2.0
TIP/PIN 2 TIP/PIN 2
SLEEVE/PIN 1
RING/PIN 3
OPERATING LEVEL
RING/PIN 3
SLEEVE/PIN 1
RETURN
SLEEVE/PIN 1
RING/PIN 3
TIP/PIN 2
SEND
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
OPERATING LEVEL
OUTPUT INPUT SIDECHAIN OUTPUT INPUT SIDECHAIN
4dBu
10dBV 4dBu
10dBV
SLEEVE
TIP TIP
SLEEVE TIP
SLEEVE TIP
SLEEVE
CHANNEL 1 CHANNEL 2
AC INPUT
95-120V /210-240V 60-50Hz
Rated Power Consumption 14W
FUSE:
210-240V: T200mAL 250VAC
95-120V: 400mA 250VAC
REPLACE FUSE WITH
CORRECT TYPE ONLY
RETURN SEND 2 1
3
2 1
3
22
23 24 25 26 27 28
110-120V
220-240V
These connectors are used to input the signal source. You can input the signal via the balanced 1/4" TRS phone
jack or XLR connector.
24. Audio In
9
25. Audio Out
These connectors are used to output the signal. You can output the signal via the balanced 1/4" TRS phone jack or
XLR connector.
This control is used to adapt this unit to either the -10dBV home recording operating level or the +4dBu professional
studio operating level.
The Input / Output Level Meter (18) is referenced automatically to the selected level, i.e. an optimum operating range
of the meter will always be ensured.
26. Operating Level Control