Samsung RSG257AABP-XAA - Manual

Before installation & calling service
If you have further questions or your refrigerator has damaged accessories or parts, contact us at 1-800-SAMSUNG (726-7864).
ENGLISH
1. Leveling & Door Alignment
• For details, refer to “Leveling
the Refrigerator” in the User
Manual.
• Insert a fl at-blade screwdriver
into a slot on the control lever.
Turn it clockwise or counter-
clockwise to level the refrigerator.
Leg
Screw Driver
[For Store Installation Only]
When the refrigerator is empty, adjust the Leveling Leg
Control by turning it clockwise or counterclockwise
with a flat head screwdriver until the Leveling Legs
contact to the floor. This will allow better balance of the
Refrigerator when it is empty. (RH22H**, RH29H**)
CAUTION
2. Automatic Ice Maker does not work
• Allow your refrigerator to operate and cool down for 24
hours (1 full day) before dispensing large quantities of
ice.
• To fi ll the ice bucket to maximum capacity, dispense a
few cubes 8 and 16 hours after installation.
12
3
6
9
(This image may
different depends
on the model.)
• If ICE OFF is lit, the ice maker will not make ice.
• To activate the ice maker, press the ICE OFF button on
the control panel so it is no longer lit.
3. Small ice cubes, ice cubes with bubbles, or slow
water dispensing
• If the water fi lter is clogged, the ice maker may produce small ice cubes
or ice cubes with bubbles.
• Replace the water fi lter cartridge with a new one.
4. Water filter replacement
• For details, see "Changing the Water Filter" in the User
Manual.
• If you have trouble inserting the water fi lter because of
high water pressure, shut off the water supply valve.
• After installation or when replacing the water fi lter,
dispense at least 1 gallon (2~3 minutes) of water to
remove trapped air from the water line. Otherwise,
water may drip from the dispenser after you dispense
water.
5. Water is not cool enough
• The fi rst glass of water may not be cold enough because the water
stored in the water tank has not cooled completely. Dispense several
glasses of water until the water is cool to your liking.
6. Water dispenser dripping
• After your refrigerator is installed, please fl ush 3 gallon of
water to remove air from the water lines. If there is air in the
water lines, water can drip from the dispenser.
• If the water line is not inserted into the coupler properly, air
could penetrate into the water line causing water to drip
from the water dispenser.
• Insert the water line into the coupler completely and slide in
the clip at the end of the coupler.
< RS** > < RS** >
1
2
Make sure the Make sure the
color of the
color of the
water lines
water lines
match.
match. < RH** > < RH** >
CAUTION
1. The Water Line must be fully inserted into the center of the
transparent coupler (Type A) or to the Guide Lines (Type B) to
prevent water leakage from the dispenser.
2. Insert the clip from the install pack and confirm that it holds the
line firmly.
Center of Transparent coupler The Guide Lines
Dispenser
clip A (1/4”) (6.35 mm) clip A (1/4”) (6.35 mm)
Type A Type B
• When reassemble the water line, connect it by same color
and seat on the hook.
• Keep the clips out of the reach of children and make sure that
children do not play with them or put them into their mouths.
7. Fridge or freezer Compartments are warm
• Allow your refrigerator to operate and cool down for 24 hours (1 full day)
to reach the temperature you set.
• When you put room temperature or warmer food into your refrigerator, it
may need an additional 24 hours to reach the set temperature.
8. Noise Clicks, Pops, Cracks, Snaps
• You may hear these noises occasionally from inside the refrigerator. This
is normal. These sounds occur when various items contract or expand
while temperatures inside the fridge are changing, especially during
defrosting. You may also hear these noises when electronic devices,
including the ice maker, are operating.
9. Display
• For details, see "Using the Control Panel" in the User Manual.
• Filter indicator : The fi lter Indicator turns red If you dispense about
300 gallons of water or about 6 months has passed. Reset the
indicator after replacing the fi lter by holding the “Energy Saver” or
“Lighting” button for 3 seconds. The indicator will turn blue or off .
• Ice off : Press the “Ice Off ”
button to turn the ice making function off .
• Cooling Off (Show Room) mode : If the Display shows the “OFF or OF
OF” code, it means that the Cooling Off function is activated and the
refrigerator is not cooling. To cancel the Cooling Off mode, press the
two buttons listed for your model in the table below simultaneously for 5
seconds.
Model Button Cooling Off Filter Reset (3 sec)
RS22H** / RSG257** Power Freeze + Freezer Energy Saver
RH22H** / RH29H** Lighting + Freezer Lighting
10. Food stored in refrigerator is frozen
• If food with too much moisture is stored near the cooling vents, it may
get frozen. Be sure to keep moist food away from the cooling vents.
11. Moving the Refrigerator
• When moving the refrigerator, pull or push it straight forwards or back.
Do not wiggle it from side to side.
DA68-01517H-05
CAUTION
CAUTION
CAUTION
DA68-01517H-05.indd 1 DA68-01517H-05.indd 1 2014. 6. 5. 11:59 2014. 6. 5. 11:59