Samsung WA48H7400AW-A2 - Manual (Page 6)

ALIGNMENT AND ADJUSTMENTS
6
Continuous Run Mode
Definition of Continuous Run Mode:
- Will continuously repeat the current cycle until the Continuous Run Mode is cancelled.
How to Enter:
- Press Delay End + Temp. Key together for 5 sec.
Continuous Run Mode:
1. Press Delay End + Temp. Key for 5 sec during Power On State (Normal User Mode) .
2. Once in Continuous Run Mode, The seven segments will no longer display “0000” and will alternate
between displaying the number of cycles of the completed course and the remaining time of the course.
3. The Continuous Run Mode will repeat the previous cycle until continuous run mode is cancelled.
4. During Continuous Run Mode, press Delay End + Temp. Key for 5 sec to return to normal user mode.
The seven segments will no longer display the number of cycles and will display the maintenance
time only.
5. If you exit Service Mode after entering it from Continuous Mode, the washing machine returns
to Continuous Mode.
6. If power is lost in Continuous Run Mode (that is, when the power plug is disconnected or the
Power key is pressed turning the washing machine off), the mode is released when the washing
machine is turned on again.
Service Mode
Definition of Service Mode:
- Service Mode enables service technicians to verify the operation of the washing machine and
do troubleshooting.
- Service Mode can be entered during all washing cycle without interrupting the cycle except
some of test modes.
- Various tests can be done with Service Mode. So, troubleshooting can be done based on the
resulting diagnostic codes.
How to Enter:
- To enter the Service Mode, press the Delay End and Pre Soak Key for 3 seconds or until the unit
sends out beeping sounds.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
Delay End + Temp.
WA7000HA WASH_WA48H_TECH MANUAL_DC68-03132G-01_EN.indd 6 2014-1-6 15:56:27