Samsung RS2630SH-XAA - Manual (Page 22)

22 22
ADJUSTING THE HEIGHT BETWEEN THE DOORS
Making small level adjustments between doors.
If the freezer door is lower than the
refrigerator door.
If the freezer door is higher than the
refrigerator door.
3) After adjusting the doors, turn the nut ( ①) clockwise( ) until the lower end of the bolt, then tighten the
bolt again with the wrench ( ➂) to fix the nut(①).
If you do not fix the nut ( ①)firmly, the bolt (➁) may be released.
2) Please adjust the height difference between the doors turning the bolt ( ➁) clockwise( ) or counter clockwise
( ).
When you turn clockwise ( ), the door goes up.
Adjustment location Adjustment location
➂ WRENCH
➀ NUT
➁ BOLT
➀ NUT
➁ BOLT
➂ WRENCH
➂ WRENCH ➁ BOLT
Please open the doors and adjust the doors as follows:
1) Release the nut ( ①) on the lower hinge until the upper end of the bolt (➁).
When you release the nut( ①), use enclosed hex wrench (➂) to turn the bolt(➁) a little counter-
clockwise. Loosen the nut( ①) with your finger.
NOTE
NOTE
NOTE
➀ NUT
DA68-01365A-1.0 5/3/06 9:59 PM Page 22