Samsung WF501ANW-XAA - Manual (Page 32)

32_ maintaining your washer
maintaining your washer
PURE CYCLE TM
Pure Cycle is a self-cleaning cycle that removes mold that may occur inside the washing machine.
1. Press the Power button.
2. Press the Pure Cycle TM button.
• Once the Pure Cycle button is pressed, the only
function that can be set is Delay Start.
3. Press the Start/Pause button.
• If you press the Start/Pause button, Pure Cycle
begins.
• Using Pure Cycle, you can clean the drum without using a cleansing agent.
• Never use Pure Cycle when laundry is in the washing machine. This may cause damage to
the laundry or a problem with the washing machine.
• If you want to use drum cleansing agent, use only 1/10 of the amount of the drum
cleansing agent recommended by the cleansing agent manufacturer. (When using a
powder-type cleansing agent , remove the liquid detergent compartment.)
The Pure Cycle Auto Indicator Function
• If the “Pure Cycle” button is lit after a wash, it indicates that
tub (drum) cleaning is required. In this case, remove the
laundry from the washing machine, turn the power on, and
clean the drum by running Pure Cycle.
• If you do not run Pure Cycle, the “Pure Cycle” indicator
turns off. However, the “Pure Cycle” indicator will light again
after two washes. Not running Pure Cycle at this point will
not cause a problem with the washing machine.
• Although the Pure Cycle Auto Indicator appears once a
month or so, the frequency may differ depending on the
number of times the washing machine is used.
CAUTION
WF501ANW-03010B-03_EN.indd Sec4:32 WF501ANW-03010B-03_EN.indd Sec4:32 2012-05-04 7:13:45 2012-05-04 7:13:45