Asus P2B-F - Manual (Page 26)

26 ASUS P2B-F User’s Manual
5. External Connectors
IMPORTANT: Ribbon cables should always be connected with the red stripe on the
Pin 1 side of the connector. The four corners of the connectors are labeled on the
motherboard. Pin 1 is the side closest to the power connector on hard drives and floppy
drives. IDE ribbon cable must be less than 46 cm (18 in), with the second drive con-
nector no more than 15 cm (6 in) from the first connector.
1. PS/2 Mouse Connector (6-pin female)
The system will direct IRQ12 to the PS/2 mouse if one is detected. If not de-
tected, expansion cards can use IRQ12. See “PS/2 Mouse Control” in BIOS
Features Setup of BIOS SETUP.
PS/2 Mouse (6-pin Female)
2. PS/2 Keyboard Connector (6-pin female)
This connection is for a standard keyboard using an PS/2 plug (mini DIN). This
connector will not allow standard AT size (large DIN) keyboard plugs. You
may use a DIN to mini DIN adapter on standard AT keyboards.
PS/2 Keyboard (6-pin Female)
WARNING! Some pins are used for connectors or power sources. These are
clearly distinguished from jumpers in the motherboard layout. Placing jumper
caps over these connectors will cause damage to your motherboard.
Connectors
III. H/W SETUP
III. HARDWARE SETUP