Asus P2B-F - Manual (Page 13)

ASUS P2B-F User’s Manual 13
III. HARDWARE SETUP
Motherboard Settings
1) KBWK p. 15 Keyboard Power Up
2) AGPFS p. 15 AGP Bus Frequency Selection
3) FS0, FS1, FS2, FS3 p. 16 CPU External Clock (BUS) Frequency Selection
4) BF0, BF1, BF2, BF3 p. 16 CPU Core:BUS Frequency Multiple
Expansion Slots/Sockets
1) System Memory p. 17 System Memory Support
2) DIMM Sockets p. 18 DIMM Memory Module Support
3) CPU Slot 1 p. 19 CPU Support
4) SLOT1, SLOT2 p. 24 16-bit ISA Bus Expansion Slots *
5) PCI1,2,3,4,5 p. 24 32-bit PCI Bus Expansion Slots
6) AGP p. 25 Accelerated Graphics Port
Hardware Monitor
1) JTPWR, JTCPU p. 23 Thermal Sensor Connectors
Connectors
1) PS2KBMS p. 26 PS/2 Mouse Port Connector (6 pin-female)
2) PS2KBMS p. 26 PS/2 Keyboard Port Connector (6-pin female)
3) PARALLEL p. 27 Parallel (Printer) Port Connector (25-pin female)
4) COM1, COM2 p. 27 Serial Port COM1 & COM2 (two 9-pin male)
5) FLOPPY p. 27 Floppy Drive Port Connector (34 pins)
6) USB p. 28 Universal Serial BUS Port Connectors 1 & 2 (Two 4-pin female)
7) Primary/Secondary IDE p. 28 Primary/Secondary IDE Connectors (Two 40-1 pins)
8) IDELED
p. 28 IDE LED Activity Light (2 pins)
9) CHA_, PWR_, CPU_FAN p. 29 Chassis, Power Supply, CPU Fan Power Lead (3 pins)
10) WOL_CON
p. 29 Wake-On-LAN Connector (3 pins)
11) IR p. 30 Infrared Port Module Connector (5 pins)
12) SBLINK p. 30 SB-Link™ Connector (6-1 pins)
13) SMB p. 30 SMBus Connector (3 pins)
14) ATXPWR p. 31 ATX Motherboard Power Connector (20 pins)
15) CHASSIS p. 31 Chassis Intrusion Alarm Lead (3 pins)
16) PWR.LED (PANEL) p. 32 System Power LED Lead (3 pins)
17) KEYLOCK (PANEL) p. 32 Keyboard Lock Switch Lead (2 pins)
18) SPEAKER (PANEL) p. 32 System Warning Speaker Connector (4 pins)
19) MSG.LED (PANEL) p. 32 System Message LED (2 pins)
20) SMI (PANEL) p. 32 System Management Interrupt Lead (2 pins)
21) PWRSW (PANEL) p. 32 ATX Power & Soft-Off Switch Lead (2 pins)
22) RESET (PANEL) p. 32 Reset Switch Lead (2 pins)
* The onboard hardware monitor uses the address 290H-297H so legacy ISA cards must not
use this address otherwise conflicts will occur.
Layout Contents
III. H/W SETUP