AutoPage RS-727LCD - Manual (Page 21)

21
4. Press the brake pedal to stop the vehicle running.
Exit the timer start: Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The LED and parking light will flash (4) times. The horn chirps (4)
times. Or
1. Press the button twice to remote start the vehicle. As soon as the vehicle is
running and the parking light have turned on or flashing.
2. Immediately depress the button then press and hold the button for 2 seconds.
(or depresses + buttons, if you program + buttons = Start / Stop
button.) The parking light will flash (4) times. The siren or horn chirps (4) times. The
vehicle is no longer programmed to start automatically.
F. TEMPERATURE CHECK (OPTIONAL)
If you installed the optional temperature sensor, you can
monitor, Through the LCD screen, the present indoor
temperature of the passenger compartment before cooling or
heating your vehicle.
Press the transmitter
buttons first, within 3 seconds press
( ) button; the in-door temperature will be shown on the
LCD screen. This reading may be higher than actual ambient
temperature due to the greenhouse and is relative only the
inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop
it,
1. Press button once on the remote transmitter under
remote start mode.
2. Move the optional remote start enable toggle switch to OFF
position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to
indicate engine stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not
start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. {“Tachometer checking type” only}
4. The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
5. Press button once on the remote transmitter under remote start mode.
6. Move the optional remote start enable toggle switch to OFF position.
(If installed)
7. The vehicle refused to start running after {3} unsuccessful attempts.