AutoPage RS-727LCD User Manual

Page 13

The vehicle doors will automatically lock after the passive arming cycle has been

completed.

PASSIVE ARMING BY-PASS: While the system is disarmed, Press the

button

twice, the system will respond with [1] chirp and LED will turn “ON”. The security
system will remain in this temporary state for as long as you wish. To exit passive

by-pass, press the transmitter

buttons and the system will return to normal

status.

I. ACTIVE DISARMING – UNLOCK & DISARM:

1. Press

button on the transmitter.

2. The siren will chirp twice and the parking lights will flash twice indicating that the

security system is now disarmed. The vehicle’s doors will unlock and the dome
light will turn on for 30 seconds upon disarming. (Note: Power door locks and
dome light must be installed with the security system.)

System Disarm

Doors Trigger

Trunk/Hood Trigger

Shock Sensor Trgr

Ignition Trigger

Clear The Flash Icon:
Press the

button 3 times within 3

seconds to clear the flash icon on the LCD
screen transmitter.

TAMPER DISARMING: If the alarm is triggered upon disarm, the system’s siren will
chirp 4 times, and the parking lights will flash 3 times.

PATHWAY ILLUMINATION: When receiving an unlock /disarm signal, this feature will
turn the parking lights “ON” for 30 seconds and for 10 seconds upon the lock signal.
TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver’s door

only when disarming the security system. Pushing the

button a second time within 3

seconds will unlock the other doors.
AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically
re-arm itself in 60 seconds after disarming with remote transmitter. Automatic rearm
will cancel if any door is opened before the 60 seconds timer has elapsed.

J. DISARMING WITHOUT A TRANSMITTER

OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:
(Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.

1. Enter the vehicle and turn the ignition switch to 'ON’ position.
2. (Alarm will sound.)
3. Within 10 seconds push and release the valet switch. The alarm will stop sounding

and enter the disarm mode. You can now start and operate the vehicle normally.

OVERRIDE THE ALARM WITH PASSWORD PIN CODE:

Unlike valet switch easily found, and defeated, this security system allows the
consumer to program a password pin code. Offering a higher level of security.

1. Enter the vehicle and turn the ignition switch to 'ON’ position. (Alarm will sound.)