Avaya Telephone Handset Lifter Accessory HL10 - Manual (Page 2)

HL10
HANDSET LIFTER ACCESSORY
4 Make And Receive Calls
4.1
Put on your headset and press the talk button.
4.2 This action directs the lifter to raise the telephone handset from
the cradle and activates the telephone line.
To make a call, use your telephone or remote dial pad to dial the
number. When your call is complete, press the talk button again
to hang up.
When receiving a call, the ring detector senses a ring from your
telephone and transmits it to your remote unit or headset. You can
answer the call by pressing the talk button and begin talking through
your headset. When finished press the talk button again to hang up.
Note: For remote ring detection to work you may need to increase
the telephone ringer volume. In some cases, telephones with multi-
ring tone choices may require trying several tones to choose the most
effective sound for ring detection.
TROUBLESHOOTING
I cannot hear a dial tone
■ Press the talk button to activate your amplifier.
■ Set lifter height switch to a higher setting, if it‘s not opening
the hookswitch.
I hear a ring on the telephone but not the remote
■ Check that the remote unit ringer switch is set to the “on” position.
■ Make sure the lifter power cord is completely plugged into the
amplifier or base.
■ Your phone’s ringer volume may have to be turned up.
The lifter does not lift the handset
■ First check that the headset works by manually lifting the telephone
handset from its cradle.
■ Reset the remote unit or headset into the charger for 20 seconds to
reestablish synchronization.
1.1
Motor
Housing
1.2
Lifting
Pad Back and Underside View
1.3
Lifter
Height
Switch
1.4
Accessory
Jack
1.5
Power
Cord
Identify
Lifter Parts
Position
and Test
Lifter
(Do not remove the
mounting tape backing
until directed to do so.)
2.2
2.1
The HL10 Handset Lifter accessory is designed to automatically lift
the telephone handset off the cradle when activated by your Avaya
amplifier.
1 Identify Lifter Parts
1.1
Motor Housing
1.2 Lifting Pad
1.3 Lifter Height Switch (low, medium, or high)
1.4 Accessory Jack
1.5 Power Cord (non-removable)
2 Position And Test Lifter
2.1
Plug the power cord into your Avaya amplifier accessory jack and
position the lifter under your telephone handset towards the earpiece.
You may need to position the lifter slightly differently for optimal lifting.
(Tip: Remove only a tiny piece of the mounting tape backing to
temporarily stick the lifter into a test position.)
2.2 Use the three position lifter height switch to adjust the lifter to its
optimum height. Test the lifter‘s position by pressing the talk button on
your amplifier, remote unit or headset. You should hear a dial tone in
the headset if the telephone handset is raised high enough.
3 Mount Lifter
3.1
Mounting Tape
Once you have determined the best position for the lifter, remove the
mounting tape backing on the top or side to best adhere the lifter to
your telephone. On a few telephones both the top and side mounting
tapes must be used to firmly grip the telephone.
QUICK START GUIDE
Make
and
Receive
Calls
3.1
Mounting
Tape
4.1
4.2
Underside View
Top View
Mount
Lifter
61851_01.qxd 12/6/01 12:31 AM Page 2