Samsung VC-8615E - Manual (Page 16)

7
IF YOU HAVE A PROBLEM
USAGE OF FLOOR NOZZLE
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
DJ68-00086C REV(0.1)
1. Motor dose not start.
2. Suction force is gradual-
ly decreasing
3. Cord dose not rewind
fully.
1. No power supply.
2. Nozzle, suction hose or
tube is blocked.
3. Check that the cord is not
twisted or wound unevenly.
1. Check cable, plug and sock-
et.
2. Romove the object.
3. Pull the cord out 2-3m and
push down the cord rewind
button.
FOR RUG / FLOOR SELECTOR
Before use make sure that the position of the selector is in the right position for the type of
surface to be cleaned.
Select the carpet indicator when cleaning carpets.
Select flat surface indicator
➁ when cleaning the floors, tiles, etc.
FOR UNIVERSAL BRUSH
Use the floor nozzle for all cleaning surfaces.
This appliance was inspected thoroughly and was in dood operating condition when it was
shipped from the factory.
If a minor problem occurs, it can usually be solved quite easily when the cause is found.
Therefore, this check list is provided for your convenience.
NOTE: For optimum efficiency, clean floor brush with DUSTING BRUSH.
This Vacuum cleaner is approved the following
EMC Directive : 89/336/EEC, 92/31/EEC and 93/68/EEC
Low Voltage Safety Directive : 73/23/EEC and 93/68/EEC
VC8615-EN 6/23/01 10:57 AM Page 10