Step 6: plug in the washer, Figure 13, Step 7: add water to the washer – Alliance Laundry Systems W001C User Manual

Page 13: Figure 14, Step 8: check lid switch, Figure 15, Step 9: check installation

Installation

39239

Step 6: Plug in the Washer

Refer to section on Electrical Requirements and plug

in the washer.

Figure 13

Step 7: Add Water to the Washer

To prevent damage to pump, do not run washer before

adding at least one quart water to the tub. If the washer

is run before any water is added, the pump seal may

overheat causing the pump to leak. Once installed, the

water retained in the drain system from the previous

cycle will provide sufficient cooling to prevent pump

seal damage.

NOTE: The agitator should not be removed except
for service. The washtub is designed to be self-
cleaning.

Figure 14

Step 8: Check Lid Switch

Washer should stop agitating and spinning when lid is

opened.

Figure 15

Step 9: Check Installation

Refer to Installer Checklist on the back cover of this

manual and make sure that washer is installed

correctly.

D254I

W391I

D254I

W391I

W376I

W376IE0A