Wesley shipboard User Manual

Page 15

DEADMAN BRAKE ASSEMBLY &

FRAME MAINTENANCE INSTRUCTIONS

1. Inspect visually that all pins are in place.

2. Check tightness of all pivot screws (Item # 27, 28, Drawing 3)

3. Wipe down – removing excess grease and foreign materials

4. Oil any visible rust or corrosion spots.

5. One drop of moly-disulfide bearing grease on each projecting clapper plate stop pins, visi-

ble through holes in the Steer Wheel.

6. One drop of non-detergent SAE 30 oil on the top end of Item # 26 (Drawing 5) on handle.

This will migrate down into Item # 8, lubricating both Item # 21 and Item # 22.

7. One drop of non-detergent SAE 30 oil applied to the following locations:

8. With pump handle turned 90 degrees, reach inside of wheels and apply oil to Clapper Plate

Pin, Item #32 (Drawing 3), one inside of each wheel.

9. Apply grease to ¼” fitting with Corrosion Control ( Mystic Mfg. P/N JT6-HI-T-P) type

grease in the following locations:

Drawing #

Item

Part #

Description

B1-13 SS

Release Plunger, Stainless Steel

B1-26 10M SS

Lift Ram 10M, Stainless Steel

B1-38B

Restrictor O-ring

B1-15.5

Pump Piston Seal

B1-17.5 SS

Pump Piston, Stainless Steel

DM-8

Housing Clamp, Adjustable

DM-28

Link Shoulder Screw

DM-27

Pivot Shoulder Screw

DM-26

Jam Nut

DM-15

Cable Tube, Welded to Handle

Part #

Description

# of Fittings

DM-09

Steer Wheel Assembly

B3-01 R7 Spec

Right Bellcrank

B3-01 L7 Spec

Left Bellcrank

B4-01T GF

Load Wheel Fork, 2