Wesley shipboard User Manual

Page 14

SHIPBOARD DEADMAN BRAKE

CABLE REMOVAL AND ADJUSTMENT

1. Remove both DM-06 and DM-12 pivot pulls

2. Loosen associated set screws in the pivot pulls.

3. Remove DM-08 short and long bolts followed by the brake cable housing and the brake ca-

ble.

4. Replace the DM-21 brake cable housing and DM-22 brake cable. Insert the DM-22 brake

cable through both the DM-08 short and long bolts. Install the DM-08 long bolt into han-

dle tube and DM-08 short bolt in the DM-01 spindle stop.

5. Replace both the DM-06 and DM-12 onto DM-22 brake cable. Insert the brake cable into

the bottom of the 3/32 hole. Tighten associated set screws.

6. To set the brake release, the DM-10 brake handle assembly Must be in Contact with the

Steer Handle when the brake is fully disengaged.

7. If the handle is not making contact with the steer handle, proceed as follows: Turn the DM-

08 long & short bolts in a clockwise rotation until the DM-10 brake handle makes contact

with the steering handle.

8. If the brake is not releasing, proceed as follows: Turn DM-08 long & short bolts in counter

clockwise rotation until the brake releases with DM-10 brake handle making contact with

the steering handle.