beautypg.com

Routine maintenance, Batteries, Battery care – Wesley PCT-3510-6SA ST User Manual

Page 20: Maintenance, Instructions, Warning caution, Warning

background image

Owner’s Manual and Service Guide – PC & PCT Series

WARNING

CAUTION

MAINTENANCE

INSTRUCTIONS

R

OUTINE

M

AINTENANCE

Before

performing

any

maintenance

or

repair

work,

isolate the batteries from the

motor and electronics by opening the circuit breaker in
(Figure 17). Simply push the red push button until the
red side lever fully opens (Figure 18). To close the
circuit breaker, simply push the red side lever to its
original closed position. (Figure 17)

F

IGURE

17

F

IGURE

18

B

ATTERIES

The standard batteries used on Pack Mule vehicles are a 36
or 48Volt battery. This manual is written around lead acid
batteries. Batteries have a maximum life. Therefore, good
maintenance is important to maximize the available life of
the vehicle’s batteries.

Always wear approved safety goggles or face shield
when handling or working around batteries.

B

ATTERY SAFETY

Always observe the following warnings when working on or
near batteries:

To prevent burns or battery explosion that could result
in severe personal injury or death, keep all smoking
materials, open flame or sparks away the batteries.

Hydrogen gas forms when charging batteries. Do NOT
charge batteries without adequate ventilation. Seat must
be raised when charging batteries. Only a 4%
concentration of hydrogen gas is explosive.

Be sure the key switch or on/off switch is in the OFF
position and all electrical accessories are off before
starting work on the vehic

le. Open the vehicle’s circuit

switch (Figure 18) before starting work on the vehicle.

The electrolyte in a lead acid battery is an acid solution
which can cause severe burns to the skin and eyes.
Treat all spills to the body and eyes with extended
flushing with clear water. Then contact a physician
immediately.

Electrolyte spills will corrode the vehicle’s structural
frame and body if not properly treated immediately. In
the event of a spill, wear proper protective clothing,
gloves, and eye wear. Thoroughly clean all affected
areas with a neutralizing solution of ¼ cup (60 mL)
sodium bicarbonate (baking soda) dissolved in 1 ½
gallons (6 L) of water.

It is highly recommended that insulated wrenches be

used when working on our electric
vehicles. Alternatively, wrap wrenches
with

vinyl

tape

to

prevent

the

possibility of a dropped wrench onto
the batteries terminals, which can
short the battery, which could result in

an explosion and severe personal injury or death.

B

ATTERY

C

ARE

1) Place battery into service and complete a full discharge

and charge cycle. Check and add approved water only
(never acid) if needed only after this first cycle is
completed.

2) Never discharge battery beyond 80% and do not

operate battery if the specific gravity is below 1.150

3) If above 115

o

F (46

o

C) allow battery to cool before

charging or operating

WARNING