Wesley PC-325-6SA - Manual (Page 33)

33 Owner’s Manual and Service Guide – PMT Series
COMPONENTS – ELECTRICAL
BA TTERY D ISCHARGE I NDICATOR (BDI)
The Curtis BDI (Figure 23) shows the 24/36V version) displays
various system parameters, such as battery state-of-charge,
operating hours or maintenance status from the Curtis motor
controller.
Features include:

Attractive, easy-to-
read, 8 character dot
matrix Liquid

Crystal Display.
• 6 LEDs -five green
to indicate battery
state-of-charge and
one red to indicate
that
a fault has
occurred.
• Displays hours of
use, battery state-of-
charge
and
messages from the
Curtis
motor
controller.
• Molded-in rear Molex style connector provides a low-cost,
rugged and reliable installation.
• Front sealed (IP65) for use in harsh environments.
The BDI in 48 volt vehicles will display battery state-of-charge
and operating/ Traction hours only. (Figure 24):
THROTTLE POSITION DEVICE
The throttle position device (Figure 25) is a rugged assembly
with IP66 throttle sensor protection for reliable use in harsh
industrial environments.
There are no user serviceable parts in the throttle position
device. No attempt should be made to open, repair, or otherwise
modify the assembly. Doing so may damage the assembly and
will void the warranty.
F IGURE 25
S OLENOID
The Pack Mule is provided with a SPNO DC Power Contactor.
This unit is sealed and is water resistant. The coil voltage is
matched to your particular vehicle operating voltage, i.e. 36V or
48V. The AC option uses 24V coil regardless of vehicle system
voltage. (Figure 26)
F IGURE 26
F IGURE 23
F IGURE 24