Campbell Scientific TORO® NW8002 Weather Station Installation - Manual (Page 7)

SECTION 1. WEATHER STATION DESCRIPTION AND INSTALLATION
1-2
FIGURE 1.2-1 Effect of Structure on Wind Flow
1.3 EQUIPMENT
The following lists describe the equipment
provided by Campbell Scientific, Inc. and those
materials provided by the user.
1.3.1 MATERIALS PROVIDED BY CSI
SRM-6A RAD Modem
ENC 12/14 Nema 4X Enclosure
101-T Nutone 16V 10 VA Transformer
Packaged Inside The Enclosure: (Figure 1.3-1)
CR10 Measurement and Control Module
SRM-6A RAD Modem
SC932 9 Pin to RS232-DCE Interface
DC112 Optional phone modem (for use
with Mir 5000 systems only,
Figure 1.9-1).
PS12-LA 12 V Rechargeable Battery
Sensors: (Figure 1.3-2)
4776 Li-Cor Solar Radiation Sensor
6575 HMP35C Temperature and
RH Probe
4830 Texas Electronics Rain Gage
5537 R.M. Young Wind Speed
5538 R.M. Young Wind Direction
Hardware:
6885 10' Tower
Crossarm & sensor mounts
Tilt base & anchor bolts
Gill radiation shield
Allen wrench
Electrician putty
Desiccant
1.3.2 MATERIALS SUPPLIED BY USER
ITEM DESCRIPTION
1 Cement
2 All conduit for 16 VAC AC power
3 AC power installation and cable
4 All communication wire from computer
to weather station, see Section 1.8 for
recommended cables
5 6 ft. copper ground rod
6 RS232 Serial Port Card for central
computer