Campbell Scientific PONDVIEW Real-Time Monitoring & Control Software - Manual (Page 17)

Section 1. Setting Up the Network and Communicating
1-7
1.3.3.4 Clock Check/Set Tab
Automated Clock Check - Enable this to compare the CR10X-TD clock to the
server computer’s clock based on the schedule defined by the other parameters
on this tab. If the CR10X-TD’s time differs from the PC time by more than a
specified amount, the CR10X-TD clock will be set automatically. Enable
should be checked. Set the clock initial time to 15 seconds after the hour. All
other settings should be left at the default value.