0 quick start instructions – Campbell Scientific Morningstar SunSaver-10 10A 12V Regulator User Manual

Page 5

requirements of the National Electrical Code Article 501-4(b)
and/or Canadian Electrical Code Article 18-156 when installing a
SunSaver in a Hazardous (Classified) Location.

ARNING

: Do not disconnect while the circuit is alive

unless the area is known to be nonhazardous.

VERTISSEMENT

: Risque D’explosion—Avant De

Deconnecter L equipment; Couper Le

Courant Ou S’assurer Que L’emplacement

Est Designe Non Gereux.

3.0 QUICK START INSTRUCTIONS

This section provides a brief overview of how to get started
using the SunSaver controller. However, please review the
entire manual to ensure best performance and years of trouble-
free service.

1. Mount the SunSaver to a vertical surface. Allow space above

and below the controller for air flow.

2. Make sure the PV and load currents will not exceed the

ratings of the SunSaver model being installed.

3. The 6 system connections to the SunSaver terminals

are numbered on the label. It is recommended that the

connections be made in order from 1 to 6.

4. Connect the BATTERY first. Use care that bare wires do not

touch the metal case of the controller.

–

BATTERY

SOLAR

LOAD

–

{

P H O T O V O L T A I C C O N T R O L L E R

12 Volts
6.5A Solar
6.0A Load

LOAD

DISCONNECT

CHARGING

Remove

Jumper

Wire for

Flooded

Battery

TEMP. SENSE

MORNINGSTAR

SEALED

FLOODED

SELECT

BATTERY